Disassembly of the 9/10 50001 PS2

Disclaimer:

MODCHIP.CA AND I WILL NOT BE RESPONSIBLE FOR ANY DAMAGE WHATSOEVER TO ANY EQUIPMENT AS A RESULT OF FOLLOWING ANY INFORMATION OR INSTRUCTION CONTAINED WITHIN OR OBTAINED FROM OR THROUGH THIS GUIDE OR THE MODCHIP.CA WEB SITE. MODCHIP.CA AND I DO NOT WARRANT THAT THE CONTENT OF THIS WEB SITE OR WEB SITES LINKED TO BY MODCHIP.CA WILL BE ERROR FREE.

FURTHERMORE MYSELF AND MODCHIP.CA WILL NOT BE LIABLE FOR ANY DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT WITHOUT LIMITATION TO, DAMAGES RESULTING FROM LOST PROFITS OR REVENUE; LOSS OF USE OF OR RELIANCE ON THE WEB SITE, INFORMATION; LOSS OF USE OF DATA OR EQUIPMENT; OR OTHER SIMILAR DAMAGES) ARISING OUT OF THE USE OR INABILITY TO USE THE WEB SITE OR INFORMATION OBTAINED THROUGH THE WEB SITE.

ALL REGISTERED TRADEMARKS REMAIN THE PROPERTY OF THEIR RESPECTIVE OWNERS, MODCHIP.CA AND I AM IN NO WAY AFFILIATED WITH, OR REPRESENTING THESE COMPANIES IN ANY WAY UNLESS SPECIFIED.

 

 

1. Disconnect all power and A/V cords from your PS2. Ensure all devices including memory cards, controllers, compact discs and/or DVD’s are removed from the system.

2. Turn your PS2 upside down and remove all eight screw caps (4 rubber and 4 plastic). These caps cover the PS2 assembly screws. Pry the caps off gently using a small flat head screw driver. Note: Four of the eight case screws are 2 1/2” in length, and all screws must be re-used in their appropriate holes only.

3. Remove the machines cover.

4. Once you open machine you will see it differs from past models as the reset button is mounted. Remove controller port screw you will be able to now remove the PS2 from the bottom shell.

5. Carefully clip up the controller cable latch and unplug cable. Set controller port to the side.

6. Remove power switch and screw underneath it.


7. Remove 4 screw securing the power supply.

8. Remove plastic isolator card and carefully unplug the fan cable.

9. You are now ready to remove the small Philips screws, there are 9 in total.

10. Once you remove the metal plate, remove the 4 side cables by carefully pulling on them and slightly wiggling side to side, then flip up the ribbon latch for the laser cable and unplug the cable from the board.

REMEMBER, WWW.MODCHIP.CA AND MYSELF WILL NOT BE RESPONSIBLE FOR ANY HARM DONE TO YOU, YOUR PS2, ANY PIECE OF ELECTRONIC EQUIPMENT, SMALL CHILDREN/ANIMALS, AND SUPPLIES.